My third and last day, the plywood betrayed me. It was going great, I had put the front piece on after gluing and screwing on the legs. I thought I was ready to put on the bottom part, but the bottom piece I had initially cut was too small, so I had to cut another one. I did that and cut out some corners for the legs with the bandsaw. It was a little too big, so I trimmed off the bottom of it with the bandsaw. Then I planned where I was going to put the pockets in and put the pockets in it. Then I screwed it in. I measured and screwed in the parts underneath the seat and I attached the backrest to the legs. I had finished by four o'clock.
Overall, I thought I did well at not only finishing on time, but also having it work. I thought I did well at adjusting to the things I had not thought about before, or problems that arose. It was a fun project, but I think if I had planned a little better, I could have been more efficient and finished sooner.
Below are some pics from yesterday.
Above is the front of the chair with the legs attached to it.
This is the chair without the front piece and legs.
This is after I attached the front piece and legs to the rest of the chair.
This is the front of my chair up close, as well as Tim.
This is what the chair looks like from the front after I put the seat on it.
This is after I attached the bottom to it.
This is the inside of the bottom of the chair.
This is the backrest of my chair.
This is the final product.
And this is Tim and I hanging out.
No comments:
Post a Comment